zilsel-invent ®

Prodaja proizvoda za hobi i profesionalnu elektorniku / mobilnu robotiku

PRODAJA KONTROLERA JEDNOSMERNIH MOTORA ZA ELEKTRONIKU I MOBILNU ROBOTIKU

Proizvode (nove i/ili korišćene) koje nemamo trenutno u ponudi,
možemo nabaviti u roku od 24h/48h/nekoliko dana/ili po dogovoru kako vama odgovara!
Svi proizvodi su novi i nekorišćeni osim ukoliko se za iste navede suprotno
Kontakt prodavac: Nenad Milosavljević, telefon: 062 17 95 321
Kontakt web stranica

Low Power Drive L298N max 2 A

Dual H-Bridge DC motor controller intended for mobile robotics. Main Chip: L298N
Operating Voltage Rang: 5 - 30 V
DC motor Max. Output Current: 2A (Peak current: 3A)
Max. Power: 25W L298N Documentation

CENA: 2950.00 RSD

Za više detalja kontaktirajte nas.
Kontakt prodavac: Nenad Milosavljević, telefon: 062 17 95 321
Kontakt web stranica

Servo Motor Motion Control on 16 channels

Controlling chip power supply range: 6.5V~12V or 4.5 V~5.5 V.
Servos power supply range: DC (voltage depends on the parameters of the servos, commonly 5V DC).
Control channels: can control 16channels at the same time, speed is precisely adjustable.
Communications input: USB or serial port (TTL, UART). (can use wireless Bluetooth module or other wireless module to wireless control)
Signal output: PWM (accuracy of 1us).
Servo motor driver resolution: 1us, 0.09 degrees.
Baud rate range: 9600 19200 38400 57600 115200 128000. (fully automatic identification, no need setting)
Support of servo motors: Futaba, Hitec or others.
PCB size: 51 mm x 43.5 mm x 1.6 mm (installation hole spacing: 42 x 35.5 mm).
Control mode: USB and serial interface (TTL) accept command mode.
Flash: on-board 512 K ROM.

CENA: 5300.00 RSD
Za više detalja kontaktirajte nas.
Kontakt prodavac: Nenad Milosavljević, telefon: 062 17 95 321
Kontakt web stranica

ULN2xxx series DIY KIT - KONTROLER ZA JEDNOSMERNI MOTOR

ULN2xxx DC motor driver kit belongs to the family of so called "do it yourself" (DIY) solutions. The solution is flexible and offers the ability to control various types of DC motors. It is intended for everyone, beginners to professionals, hobbyists, enthusiasts and belongs to everyone. Do not hesitate, start your robot or motor control project with ULN2xxx kit, you can expect large numbers of different possibilities with ULN2xxx DC motor driver kits.

CENA: 500.00 RSD
Za više detalja kontaktirajte nas.
Kontakt prodavac: Nenad Milosavljević, telefon: 062 17 95 321
Kontakt web stranica

ULN2803 DC Motor Driver - Assembled Edition - KONTROLER ZA JEDNOSMERNI MOTOR

The ULN2803 DC motor driver assembled edition comes with four preassembled channels and ULN2803 integrated circuit at the same time providing the possibility for custom/DIY implementation. It supports a variety of algorithms for motor control: stepping, microstepping, PWM etc. With additional LED matrix, software development is simpler.

CENA: 1000.00 RSD
Za više detalja kontaktirajte nas.
Kontakt prodavac: Nenad Milosavljević, telefon: 062 17 95 321
Kontakt web stranica

SERPENT I DIY PCB KIT

SERPENT I is H-Bridge DC Motor controller/driver based on power MOSFET transistor IRF3710. SERPENT I is an independent solution which could be easily used with any currently available embedded system development board. SERPENT I does not provide any predefined connector except screw connectors. Instead, matrix 4x8 provides a generic solution in order to build right adapter connectors for target development board...

CENA: 1500.00 RSD
Za više detalja kontaktirajte nas.
Kontakt prodavac: Nenad Milosavljević, telefon: 062 17 95 321
Kontakt web stranica

SERPENT I - DC Motor Driver - ASSEMBLED EDITION

CENA: 2500.00 RSD
Za više detalja kontaktirajte nas.
Kontakt prodavac: Nenad Milosavljević, telefon: 062 17 95 321
Kontakt web stranica

SERPENT II - Pit VIPER Rattle - DC/Stepper Motor Driver - PCB DIY EDITION

SERPENT II, Codename: Pit VIPER Rattle, is the four channel power MOSFET current amplifier, DC Motor and Stepper Motor controller/driver designed according to the power MOSFET transistor IRF3710. SERPENT II is an independent solution which could be easily used with any currently available embedded system development board. SERPENT II does not provide any predefined connector except screw connectors for each power MOSFET channel. Instead, protoboard provides a generic solution in order to build right adapter connectors for the target development board...

CENA: 1500.00 RSD
Za više detalja kontaktirajte nas.
Kontakt prodavac: Nenad Milosavljević, telefon: 062 17 95 321
Kontakt web stranica

SERPENT II - Pit VIPER Rattle - DC/Stepper Motor Driver - ASSEMBLED EDITION

CENA: 2500.00 RSD
Za više detalja kontaktirajte nas.
Kontakt prodavac: Nenad Milosavljević, telefon: 062 17 95 321
Kontakt web stranica

Read about DIY PCB @:

         Zilsel invent provides
         independent platform/ecosystem
         for motor control.

         Build your robot platform
         independent of
         the control logic.

         Build once use many times...

zilsel blogspot

zilsel facebook

zilsel twitter

zilsel linkedin